Passive Multiple – 2HP

Passive multiple 2HP
Passive Multiples are the simplest modules you can find in a Modular Synth. But you really need a lot of them!

A multiple simply allows you to share signals between modules: One module’s output to several other inputs.

A passive multiple means that the signal is simply shared without any electronic modification. Also, you don’t need to power it. It won’t draw any current.

Passive Multiple, side view
Passive Multiple, rear view

Passive Multiple is made of two independent or chained sub circuits. You can choose between the two modes by adding or removing a small blob of solder on the back of the PCB.

Any jack in a sub circuit can act as the input and as an output. It’s important to connect only one module output to the Passive Multiple input.
If you connect two outputs to the same sub circuit, it could damage the weakest module’s output.
In principle, outputs on commercial modules are protected, but you never know.

3D render

3D render

In chained mode (see above, how to select the mode), it is possible to daisy chain several Passive Multiple sub circuits. If jack n°5 is unconnected, the input signal can be delivered by sub circuit #1.

Plugging in a jack in connector J5 disconnects the sub circuit #2 from sub circuit #1.

Front panel render
PCB Top Side render
PCB Top Side
PCB Bottom Side render
PCB Bottom Side

Downloads and documentation

Buy PCBs, kits and assembled modules

Passive Multiple is available at Tindie!
I sell on Tindie

Leave a Reply

Your email address will not be published. Required fields are marked *